It is impossible to use measurement tools if you are navigating and vice versa. On the Review tab, select the Measure panel to access the measurement tools. Display units are used for all measurements. Models can measure between points using measurement tools. When finished selecting points, press Enter. A measure tool lets you move and rotate currently selected objects.Measures area and perimeter by specifying corner points. Check the regression graph for precision. Measures the distance between two points, as well the X and Y distances and the angle relative to the UCS. Identify which point group includes the surveyed centerline points. Once i recalibrate the rack, no Invalid reading of measured point occurred. You can also measure the distance or area of a sequence of points by selecting Distance or Area. this week i encounter 'Invalid reading of measured point', after 4 days searching, with hexa guy on the phone, we discovered this was cause by moved probe rack. I specify an offset of 0.00m and interval of 1.5m. the command line shown the end station of 36.5m, which is correct for the length of the line. I select the line and then enter twice to default the start and end. Just make sure that in the Global options editor >Interface > Measure that Use center lines tick box is selected. When i select the measure object option to create the points the following occurs: 1. MEASURE creates a vertical and horizontal ray from the location of the pointing device, and displays the distance and angles between any objects the vertical and horizontal rays intersect. You can pick any two pipes then select shortest distance and you’ll get the measurement from centerlines of pipes. To access a screen or command from the Favorites list, tap the Favorites. You can use the Node object snap to draw an object by snapping to the point. The points or blocks are placed in the Previous selection. Use PTYPE to set the style and size of all point objects in a drawing. You can measure the length of objects, the angle and distance between objects, and the radius of circles and arcs by clicking MEASURE, then moving the pointing device in the drawing area. Measuring topo points in a Conventional Survey. The resulting points or blocks are always located on the selected object and their orientation is determined by the XY plane of the UCS.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |